Pioneer PDK-WM03 Bedienungsanleitung PDF herunterladen (Seite 17)

E-6

1 Use 2 of the included M8 screws to fasten one of the

two brackets to the plasma display in the direction

shown on the diagram.

2 Line up the screw holes (ø9, indicated on the dia-

gram) in the display fittings (one each for left and

right sides) with the screw holes (M8) in the rear panel

of the plasma display, and fasten the display fittings

using 2 of the included M8 screws for each fitting.

There are two display fittings, one for the right side, the other for the left. Mount the fittings so that their eye bolts are at the

inner side. Attach the fittings so that when viewed from the rear of the plasma display, the eye bolts are positioned at the

right side. Attaching the fittings in the opposite orientation will cause damage to the plasma display.

Reference: (PDP-614MX only)

When using the PDK-TS06 optional stand, the

display fittings can be attached with the plasma

display mounted on the stand.

When lifting the display, do not allow the stand to be

lifted together with the display. If the stand were to

come off, it could cause injury or damage.

1. Attaching the Bracket(s) and Display Fittings to the Plasma Display

Vertical Installation (PDP-614MX only)

Screw the wall mounting unit to the wall using commercially

available anchors or the 6 M8 screws.

Mount with the upper hook holes at the top.

2. Attaching the Wall Mounting Unit to the Wall

NOTE: Make sure that the anchors or screws are

fastened into sections of the wall at which there

are beams. (Use anchors or screws that are suited

for use on the type of wall on which the unit is

being mounted.) For details, see the following

Table of Wall Material vs. Anchors and Screws.

Gypsum board

Plywood

Concrete

Block

ALC

Mortar

Brick

Wooden posts

* The extraction strength should be 500 kg or greater per position.

Wall Material Anchor

* Do not mount on plaster or plywood boards.

Be sure to fasten into a beam.

All anchors (850) or bolt plugs (300)

Coach screws (ø8 x 50)

Tie-Lock anchors (No. 25)

■ Table of Wall Material vs. Anchors and Screws

For the Right

Center for 61” types

610

950

400

591

494.5

Upper hook holes

Lower hook holes

φ9 φ9

ブラケット

アイボルト

For the Left

Bracket

Eye bolt

CAUTION Models PDP-615PRO, PRO-1410HD, and PDP-615EX do not support vertical installation.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 61 62

Kommentare zu diesen Handbüchern

Keine Kommentare

Pioneer PDK-WM03 Bedienungsanleitung Seite 17

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Heimkinosysteme Pioneer PDK-WM03