Pioneer x920 Installationsanleitung PDF herunterladen (Seite 22)

! The cords must not cover up the area

shown in the figure below. This is neces-

sary to allow the amps and navigation me-

chanism to dissipate heat.

Do not cover this area.

! The semiconductor laser will be damaged

if it overheats, so don’t install the naviga-

tion unit anywhere hot —for instance, near

a heater outlet.

Parts supplied

The navigation unit Binding screw

(5 mm × 8 mm)

(8 pcs.)

Flush surface screw

(5 mm × 8 mm)

(8 pcs.)

Installation using the screw holes

on the side of the navigation unit

% Fastening the navigation unit to the

factory radio-mounting bracket.

Position the navigation unit so that the brack-

ets screw holes and its screw holes are

aligned (are fitted), and tighten the screws at 3

or 4 locations on each side.

Use either the binding screws (5 mm × 8 mm)

or flush surface screws (5 mm × 8 mm), de-

pending on the shape of the bracket’s screw

holes.

If the pawl gets in the

way, bend it down

Dashboard or console

Binding screw or

flush surface screw

Be sure to use the

screws supplied

with this navigation

system.

Factory radio mounting bracket

Section

Installation

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 55 56

Keine Kommentare

Pioneer x920 Installationsanleitung Seite 22