Pioneer AVH-P3400DVD Bedienungsanleitung PDF herunterladen (Seite 51)

1 Display the DSP function menu.

Refer to Introduction of menu operations on

page 43.

2 Touch Speaker Setting.

3 Touch a or b to select Subwoofer (sub-

woofer).

Front (front speakers)—Center (center speak-

er)—Rear (rear speakers)—Subwoofer (sub-

woofer)—Phase (subwoofer setting)

4 Touch d to turn subwoofer output on.

# To turn subwoofer output off, touch c.

5 Touch b and then touch c or d to se-

lect the phase of subwoofer output.

Reverse—Normal

Note

When playing a 2-channel mono source with

Dolby Pro Logic II turned on:

! No sound is emitted if the center speaker set-

ting is Small or Large and no center speaker

is installed.

! Sound is only emitted through the center

speaker if it is installed and set to Small or

Large.

Adjusting the speaker output

levels

Fine adjustments of the speaker output level

can be made by listening to audio output.

First, use the test tone to adjust the speaker to

an approximate level, and then use this func-

tion to make fine adjustments.

1 Display the DSP function menu.

Refer to Introduction of menu operations on

page 43.

2 Touch Speaker Level.

3 Touch a or b to select the speaker to

be adjusted.

Front-L (left front speaker)—Center (center

speaker)—Front-R (right front speaker)—

Rear-R (right rear speaker)—Rear-L (left rear

speaker)—Subwoofer (subwoofer)

# Speakers with the size set to Off cannot be se-

lected. (Refer to Setting the speaker setting on the

previous page.)

4 Touch c or d to adjust the speaker out-

put level.

Range: +10 to –10

Note

You will get the same results whether you adjust

the speaker output levels with this mode or with

Test Tone.

Selecting a cross-over frequency

The frequency under which sounds are repro-

duced through a subwoofer can be selected.

For example, if the size of one of the installed

speakers is set to Small, you can select the fre-

quency under which sounds will be repro-

duced through a speaker set to Large or a

subwoofer.

1 Display the DSP function menu.

Refer to Introduction of menu operations on

page 43.

2 Touch Cross Over.

3 Touch a or b to select the speaker to

be adjusted.

Front (front speakers)—Center (center speak-

er)—Rear (rear speakers)—Subwoofer (sub-

woofer)

4 Touch c or d to select the cross-over

frequency.

63Hz—80Hz—100Hz—125Hz—160Hz—

200Hz

En

51

Section

12

Menu operations

Menu operations

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 111 112

Kommentare zu diesen Handbüchern

Keine Kommentare