Pioneer DEH-6100BT Bedienungsanleitung PDF herunterladen (Seite 40)

4 Push MULTI-CONTROL left or right to

select the desired level.

LOW (low)—MID (mid)—HIGH (high)

Using subwoofer output

This unit is equipped with a subwoofer output

which can be turned on or off.

Also, phase can be selected between normal

and reverse.

1 Press SW/BASS to display the subwoo-

fer setting mode.

Press SW/BASS repeatedly to switch between

the subwoofer setting modes in the following

order.

SUB W1 (subwoofer on/off setting) setting

mode—SUB W2 (subwoofer setting) setting

mode

2 Select SUB W1 setting mode.

3 Press MULTI-CONTROL to turn subwoo-

fer output on.

NORMAL appears in the display. Subwoofer

output is now on.

# To turn subwoofer output off, press

MULTI-CONTROL again.

4 Push MULTI-CONTROL left or right to

select the phase of subwoofer output.

Push MULTI-CONTROL left to select reverse

phase and REV appears in the display. Push

MULTI-CONTROL right to select normal phase

and NORMAL appears in the display.

Note

You can also switch to this setting mode in the

menu that appears by using MULTI-CONTROL.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad-

just the cut-off frequency and the output level

of the subwoofer.

! When the subwoofer output is on, you can

select SUB W2.

1 Press SW/BASS to display the subwoo-

fer setting mode.

Press SW/BASS repeatedly to switch between

the subwoofer setting modes in the following

order.

SUB W1 (subwoofer on/off setting) setting

mode—SUB W2 (subwoofer setting) setting

mode

2 Select SUB W2 setting mode.

3 Push MULTI-CONTROL left or right to

select cut-off frequency.

50—63—80—100—125 (Hz)

Only frequencies lower than those in the se-

lected range are outputted from the subwoo-

fer.

4 Push MULTI-CONTROL up or down to

adjust the output level of the subwoofer.

Each time MULTI-CONTROL is pushed up or

down, subwoofer level increases or decreases.

+6 to -24 is displayed as the level is increased

or decreased.

Note

You can also switch to this setting mode in the

menu that appears by using

MULTI-CONTROL.

Using the high pass filter

When you do not want low sounds from the

subwoofer output frequency range to play

from the front or rear speakers, turn on the

HPF (high pass filter). Only frequencies higher

than those in the selected range are output

from the front or rear speakers.

1 Display the audio menu.

Refer to Introduction of audio adjustments on

page 38.

2 Use MULTI-CONTROL to select HPF.

Audio Adjustments

En

40

Section

09

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare