Pioneer VSX-819H-S Bedienungsanleitung PDF herunterladen (Seite 24)

Connecting up03

•If the surround speakers cannot be set

directly to the side of the listening position

with a 7.1-channel system, the surround

effect can be enhanced by turning off the

UP Mix function (see Setting the Up Mix

function on page 37).

•Try not to place the surround speakers

farther away from the listening position

than the front and center speakers. Doing

so can weaken the surround sound effect.

Caution

•Make sure that all speakers are securely

installed. This not only improves sound

quality, but also reduces the risk of

damage or injury resulting from speakers

being knocked over or falling in the event of

external shocks such as earthquakes.

Switching the speaker system

Three speaker system settings are possible

using the SPEAKERS button.

• Use the SPEAKERS button on the front

panel to select a speaker system setting.

Press repeatedly to choose a speaker system

option:

• SPA – Sound is output from the speakers

connected to the A speaker terminals and

SURROUND BACK PRE OUT

(multichannel playback is possible).

• SPB – Sound is output from the two

speakers connected to sp eaker system B

(only stereo playback is possible).

• SPAB – Sound is output from sp eaker

system A, the two speakers in speaker

system B, and the subwoofer.

Multichannel sources are downmixed only

when the STEREO or A.L.C mode is

cted for stereo output from speaker

systems A and B.

• SP – No sound is output from the

speakers but from the headphone jack.

Connecting an IR receiver

If you keep your stereo components in a closed

cabinet or shelving unit, or you wish to use the

sub zone remote control in another zone, you

can use an optional IR receiver (such as a Niles

or Xantech unit) to control your system instead

of the remote sensor on the front panel of this

receiver.

1 Connect the IR receiver sensor to the

IR IN

jack on the rear of this receiver.

For more infor mation on connecting the IR

receiver, see the Installation Instructions for

the IR Receiver.

Note

1The subwoofer output depends on the settings you made in Speaker Setting on page 42. However, if SPB is selected above,

no sound is heard from the subwoofer (the LFE channel is not downmixed).

SPEAKERS

CONTROL

MULTI-ZONE

ON/OFF

SPEAKERS

2 You can use speakers with a normal impedance between 6 Ω and 16 Ω. However, be aware that only the front speakers are set

to a value between 12 Ω and 16 Ω when you select SPAB.

3• Remote operation may not be possible if direct light from a strong fluorescent lamp is shining on the IR receiver remote

sensor window.

• Note that other manufacturers may not use the IR terminology. Refer to the manual that came with your component to check

for IR compatibility.

• If using two remote controls (at the same time), the IR receiver’s remote sensor takes priority over the remote sensor on

the

front

panel.

VSX-819H_MYS.book 24 ページ２００９年１月１６日　金曜日　午後８時３４分

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 211 212

Kommentare zu diesen Handbüchern

Keine Kommentare

Pioneer VSX-819H-S Bedienungsanleitung Seite 24

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Empfänger und Verstärker Pioneer VSX-819H-S