Pioneer VSX-709RDS Bedienungsanleitung PDF herunterladen (Seite 22)

Press SETUP and hold for three seconds to

select the preset mode.

The LED will blink twice.

To cancel the preset mode

Press SETUP.

Press the MULTI CONTROL button for the

component you want to control.

Each button can be set to control one of the following components

DVD

: DVD/LD player or DVD Recorder

: TV , Satellite tuner or Cable TV tuner

: CD player, CD-R, Tape deck or MD recorder

CD-R

: CD player, CD-R, Tape deck or MD recorder

VCR

: VCR or DVR (DVD Recorder)

TVC

: TV , Satellite tuner or Cable TV tuner

TUN

: FM/AM tuner

Use the number buttons to enter the 4 digit

preset code.

The LED will blink after each digit is input and will blink twice to

confirm a valid code has been input.

If the LED shows one long blink it means an invalid code has been

input. Check the preset code list and try again. If you are not able to

input a preset code you can refer to page 24 to teach the remote

control individual commands.

Repeat steps 1 through 3 to recall preset codes for as many

components as necessary.

Press SETUP to exit the preset mode.

The remote control returns to the previous operation mode.

It will also return to the previous mode after ten seconds of inactivity.

• The RCV (Receiver) button cannot be preset.

• You can only input a code for the component type written on

each MULTI CONTROL button. See page 27 for information

on how to program a different type of component than speci-

fied on the button.

• If you recall a preset code for the tuner (TUN MULTI CON-

TROL), you will not be able to control the built-in tuner of this

receiver using the remote control. To reset the remote control

to the built-in tuner, input the preset code 0080.

Setting Up the Remote Control

In addition to controlling the receiver, the supplied remote control can operate your other components (DVD,

MD, VCR, TV, LD, CD, etc.). If your component(s) are listed in the “Preset Code List” on pages 58 to 65, simply

recall the corresponding preset code.

Recalling preset codes (VSX-709RDS)

The following steps show you how to recall preset codes for each MULTI CONTROL button. Once the preset

code is assigned, pressing the button will automatically set the remote control to operate the respective

component.

• Refer to “Preset Code List” on pages 58 to 62 for the components and manufacturers

available.

• Refer to “Controlling the Rest of Your System” on pages 52 to 55 for detailed explana-

tions on how to operate your other components.

1,4

Preparations

LED

Î

SOURCE

DISC

TV CONTROL

TV VOL

TVFUNC

ENTER

D.ACCESS BAND CLASS

CH SELECT CH LEVEL

AV PRE-PROGRAMMED AND LEARNING

REMOTE CONTROL UNIT

DSP TEST TONE

FL DIMMER

LOUDNESS FUNCTION SETUPMUTING

MPX DISPLAY RF ATT

ST ST

CHANNEL

MASTER VOLUME

MULTI CONTROL

DVD TV VCR CD-R

RCV CD TUN TVC

RECEIVER



¢

3



¡

MIDNIGHT

SIGNAL SELECT EFFECT

+10

5.1CH ATT

123

456

789

()

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 67 68

Kommentare zu diesen Handbüchern

Keine Kommentare

Pioneer VSX-709RDS Bedienungsanleitung Seite 22

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Empfänger und Verstärker Pioneer VSX-709RDS